Badlands Motorcycle Products

OEM WIRING DIAGRAM FOR
AUTOMATIC TURN SIGNAL SHUT OFF

1. Read instructions carefully before beginning. Now is the time to make the decision on whether you want to install this devise yourself or get help from a professional.
2. The timer devise may be mounted between the fuel tanks, under the seat, or behind a side cover depending on your model of motorcycle.
3. Where ever you decide to mount your timer make sure you have near by access to your main wire loom. Keep in mind you want to conceal the timer as well as your electrical connections.
4 Now that you have mounted your timer follow steps 1 thru
10 on your instruction sheet.
5. The manufacturer, its distributors, and sellers of this product cannot predetermine or foresee the improper use of this product therefore we will not be responsible for the misuse of this product.

OPERATION INSTRUCTIONS FOR TURN SIGNAL TIMER

Press the turn signal button and release for approximately 7 seconds of that turn signal flashing.
The turn signal flashing starts when the button is pressed, but the 7 second timer starts when the button is released.
Pressing the button while the light is flashing will restart the 7 second timer and extend the flashing.
The two sides operate independently. Both may be flashing at the same time.
WARNING To "cancel" the turn signal if you do not want it to continue to indicate a turn, press both buttons at once. This will indicate a hazard rather than a turn. This is useful for the case where a lane change was done just before an intersection and you don’t want other traffic to think you are planning to turn.
* NOTE If you are the mechanic installing this product be
sure the customer receives a copy of the operating instructions.